Installing shower standing handles can be extremely beneficial for those with reduced mobility or limited physical strength. As they provide an extra point of support, those using the shower can balance safely and securely while showering. Additionally, the handles provide additional stability when it comes to stepping in and out of the shower, reducing the risk of slipping and falling. Moving around in the shower will become easier with the use of a handle.
There are certain things you must keep in mind when installing a shower handle. You need to mount the shower handle directly to the tile/tub or a separate wall structure as far from the wet walls as possible. If the wall structure is not strong enough to support the weight of the person, you must use a reinforcement plate and anchor.
A reinforcement plate is a piece of metal or hard plastic with holes drilled in it or attached to a plastic wall. You must use an anchor that is screwed into the reinforcement plate and through your tile wall. An anchor is a metal fastener with a screw on each side. You can screw them into drywall, plaster, and concrete. Under no circumstances should you drill through the porcelain, as this will cause the tile to crack and break.
What’s the Most Popular way to Install Shower Standing Handles?
You can install shower handles in several different ways. Let’s look one of the most popular techniques of installing shower handles. The first technique is to mount the handle on the wall directly behind the shower head. This technique is popular because it uses existing holes and doesn’t require any additional drilling. People usually mount the handles approximately 8 to 10 inches off the floor, which is around 36 inches above the shower drain.
You can mount the handles over the shower head or next to it. In either case, they must be high enough so that the water from the shower doesn’t hit them, but low enough that they aren’t blocked by your hand if you’re tall. Installation of the handle is dependent on the size of the shower and the type of materials used for installation. If you mount the handle on the shower wall, make sure you have enough space to slide a hand underneath when you’re getting into or out of the shower. Otherwise, you’re going to bang your head every time.
Installing shower standing handles is an easy task that you can do with a few basic tools. First, make sure the area for installation is clean and dry. Then, use a drill to make holes for the handle mounting screws. Place the handle in its desired location and secure it with the screws. Finally, use a wrench to torque the screws to the required level to ensure a secure fit.
Conclusion
Installing shower handles is a relatively straightforward process. First, you will need to determine the height at which you should install the handle and mark the spot on the wall. Next, use a drill to create a pilot hole in the wall where the handle will go. Finally, insert the anchors and screws into the pilot hole and attach the handle firmly to the wall.
Make sure to use a level and plumb bob to ensure that the handle is perfectly level before tightening all screws. Installing shower standing handles is relatively easy, as long as you have the right tools and materials. You may need to adjust the height of the handle so that it’s comfortable to use. Finally, apply caulking around the edges of the handle to ensure a watertight seal.
Read more article at DigitalJournalTimes.
Leave a Reply